Eminent EM8655 Manual descargar pdf (Pagina 4)

4 | ENGLISH

Remark: If the group of a sensor needs to be changed, all sensors need to be paired

with the alarm system once more. It is not possible to remove one single sensor from

a group ! (See chapter “Delete all wireless sensors by text message”)

Remark : It’s recommended to install detectors that needs to be operational 24-hours,

for example smoke detectors, in the 24-hours-group.

3.2 Pair the motion detector

Please wait till the motion sensor is fully started and passed the self-test (all LEDs will

go off).

Enter the password and press button on the control panel. The LED will turn on.

Now trigger the motion detector. If you hear a beep the sensor is registered to the

system. If you hear 2 beeps this indicates this sensor is already registered.

Notice: During the registration process be sure no other sensor is triggered. If a

motion detector is in the same room make sure you cover the motion detector or place

the motion detector temporarily in a different room.

3.3 Microwave potentiometer

The microwave potentiometer is used to adjust the microwave detection range. You

can adjust the detection range according to your requirements. The EM8655 is set to

maximum detection range at default.

3.4 JP1 sensitivity jumper

JP1 is the jumper to set the sensitivity. When the jumper is set to 1&2, the sensors

sensitivity is set to high, supplying maximum detection range.

24-hours-group

Home-group

Normal-group

Single-group

1 2 3 4 5 6 7 8

Sin comentarios

Eminent EM8655 Manual Pagina 4